A 320 kbps MP3 from MP3Juice is a larger file, not a better-sounding one, because the YouTube audio it is made from runs at roughly 128 to 160 kbps for most videos. The figure is the highest bitrate in the MP3 standard, which is why people reach for it by default.
The number describes how much data the file spends on each second of sound. It says nothing about the quality of the recording that was fed into it. This article covers what the figure means, how much space each bitrate takes and which setting makes sense for a file that starts as YouTube audio.
What 320kbps means in an MP3
Bitrate is the amount of data used for each second of audio. At 320 kilobits per second, an MP3 spends 320,000 bits, or 40,000 bytes, on every second. It is the highest bitrate in the MP3 standard.
MP3 is a lossy format at every bitrate. The encoder discards the parts of the sound that listeners are least likely to notice and keeps the rest. A higher bitrate lets it discard less. At 320 kbps, an MP3 made from a CD-quality original is very hard to tell apart from that original for most people on most equipment.
Bitrate can be constant or variable. A constant 320 kbps file spends the same amount on a quiet intro as on a dense chorus. Variable settings spend more where the music is complex and less where it is simple, so a good variable file can sound just as clean at a smaller size.
The MP3 bitrate guide compares 128, 192, 256 and 320 kbps in more detail.
How much space each bitrate takes
File size follows directly from bitrate and length. Divide the bitrate by eight to get kilobytes per second, then multiply by the duration in seconds. The table gives the size per minute, per four-minute song and per 100 such songs at four bitrates.
| Bitrate | Per minute | Four-minute song | 100 such songs |
|---|---|---|---|
| 128 kbps | 0.96 MB | 3.8 MB | About 384 MB |
| 192 kbps | 1.44 MB | 5.8 MB | About 576 MB |
| 256 kbps | 1.92 MB | 7.7 MB | About 768 MB |
| 320 kbps | 2.4 MB | 9.6 MB | About 960 MB |
These figures use decimal megabytes and ignore cover art and tags, which add a little. The pattern is what matters: 320 kbps takes two and a half times the space of 128 kbps.
Does a 320 kbps MP3 made from YouTube audio sound better?
No. An encoder can only keep what it is given, and it cannot put back detail that an earlier compression step removed.
This matters because the audio on YouTube is already compressed. Most videos carry AAC or Opus audio at roughly 128 to 160 kbps. That stream is the raw material for any MP3 made from a YouTube video, whichever tool does the converting. The encoding itself is described in how YouTube compresses audio.
So when a 320 kbps option is listed for a result, the label tells you how the MP3 was written, not how good the sound is. A 320 kbps file made from a 130 kbps stream is far larger than its source and no better. The YouTube to MP3 converter page has a section on choosing a quality for the same reason.
What a second encoding does to the sound
Turning AAC or Opus into MP3 means compressing sound that has already been compressed. Each lossy step makes its own decisions about what to discard, and the losses add up. Engineers call this generation loss.
A generous bitrate for the second step keeps the added damage small, and that is all it can do. MP3 is an older and less efficient codec than AAC or Opus, so it needs a somewhat higher bitrate to carry the same sound. For a typical YouTube source, 192 kbps gives the encoder that room. Going on to 320 kbps adds megabytes without adding music. The same logic applies to converting a 128 kbps MP3 up to 320 kbps: the file grows and nothing returns.
The page on why a downloaded MP3 sounds different from the stream looks at this from the listening side.
How to check what a file really contains
The bitrate in a file's properties reports how the file was written. It cannot reveal the source. A spectrum view can: audio from a low-bitrate source often stops sharply at around 16 kHz, while a 320 kbps MP3 made from a CD reaches about 20 kHz. The steps for Windows, Mac and phones are in how to check the bitrate of an MP3.
Which bitrate to choose on MP3Juice
Start from how you will listen, then take the smallest file that does the job. For a file that starts as YouTube audio, four situations cover most choices:
- Phone speaker, podcasts and talks: 128 kbps is enough. Speech survives compression well, and a small speaker hides what is lost.
- Earbuds, car stereo or Bluetooth speaker: 192 kbps is the practical choice for music taken from a YouTube video.
- Good wired headphones or a hi-fi: 192 kbps. Flaws you hear at this level are almost always in the source, and a larger file will not remove them.
- Tight storage or a small data plan: 128 kbps takes a third less space than 192 kbps and well under half the space of 320 kbps.
The source video and the external conversion service decide which options MP3Juice can list, so the choice may differ from one result to the next, and seeing only one or two options is normal. A better upload of the same song helps more than a higher number. Press Play on the result to hear it before you download.
When 320 kbps is the right choice
The highest bitrate earns its size when the original is better than the MP3 will be. That holds in three cases:
- You are converting your own recordings, or lossless files you have the right to convert, from WAV or FLAC, the two lossless formats in the audio format comparison. Here 320 kbps keeps as much as MP3 can.
- Your player or car stereo only accepts MP3 and you want the closest thing to the original it can handle.
- You listen on good headphones or speakers in a quiet room, where small artefacts are easiest to hear.
A conversion of that kind runs in an encoder on your own computer. The MP3 converter on this site works from YouTube links and takes no file uploads.
Quality aside, convert or save a recording only if you made it, if a licence or permission covers it, or if it is public domain or openly licensed. National rules differ.
A fair way to compare by ear
Numbers settle size. Only listening settles sound, and it has to be done fairly. A fair comparison takes four steps:
- Take one recording and prepare two versions of it at different bitrates from the same original.
- Match the loudness. The louder file tends to win a comparison even when it is the worse one.
- Have someone else switch between the files without telling you which is playing, or use an ABX comparison tool.
- Repeat at least ten times and count how often you were right. A score near half means you are guessing.
Many listeners find they cannot reliably separate 192 from 320 kbps this way. The comparison that matters more is between a good source and a poor one. The article on what decides MP3 audio quality fills in the background.
